On the first four photos, you have the status of the printer mirrors, that appear in very good condition.
So I changed the main mirror . I had slight blow with compressed air the 4 mirrors , but I do not have to clean them with PEC * PADs.
The tank bottom seems to be in good condition. Below, my test prints with butterflyclip test model and a gearing.
For some time , I have cover open alerts, I do not know where is the sensor.
- main mirror
- secondary mirror
- view of X galvanometer
- view of Y galvanometer
- bottom of the tank
- butterblyclip test impression
- butterblyclip test impression
- a bad impression
- a good impression (the very first impression at the beginning)
- alert cover open